D-Link xStack DGS-3420 Series - Page 916

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
911
Success.
DGS-3420-28SC:admin#
16-16 config stp trap
Description
This command is used to configure sending the STP traps.
Format
config stp trap {topo_change [disable | enable] | new_root [enable | disable]} (1)
Parameters
topo_change - Specify the state of sending topology change traps. The default state is enable.
enable - Enable sending topology change traps.
disable - Enable sending topology change traps.
new_root - Specify the state of sending new root traps. The default state is enable.
disable - Disable sending new root traps.
enable - Enable sending new root traps.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the sending state for STP traps:
DGS-3420-28SC:admin#config stp trap new_root enable
Command: config stp trap new_root enable
Success.
DGS-3420-28SC:admin#