D-Link xStack DGS-3420 Series - Page 97

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
92
4-41 show radius source_ipif
Description
This command is used to display specified source interface for all outgoing RADIUS packets.
Format
show radius source_ipif
Parameters
None.
Restrictions
Only Administrator level can issue this command.
Example
To display specified source interface for all outgoing RADIUS packets.
DGS-3420-28SC:admin#show radius source_ipif
Command: show radius source_ipif
IP Interface : if_v200
IPv4 Address : None
IPv6 Address : None
DGS-3420-28SC:admin#
4-42 create tacacs server_host
Description
This command is used to create a TACACS server host.
Format
create tacacs server_host <ipaddr> {port <int 1-65535> | timeout <int 1-255> | retransmit <int 1-
20>}
Parameters
<ipaddr> - Enter the IP address of the server host.
port - (Optional) The port number of the TACACS server host.
<int 1-65535> - Enter the value between 1 and 65535. The default value is 49.
timeout - (Optional) Specify the time in second to wait for the server to reply.
<int 1-255> - Enter the value between 1 and 255. The default value is 5.