D-Link xStack DGS-3420 Series - Page 988

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
983
10.1.1.1./desxxxx.had. Note: No spaces are allowed in the <string>.
<string 128> - Syntax: rcp: username@ipaddr/directory/filename. Example for full path:
user_name@10.1.1.1/home/user_name/desxxxx.had; Example for relative path:
user_name@10.1.1.1./desxxxx.had; Example for omitted user name in RCP string:
10.1.1.1./desxxxx.had. Note: No spaces are allowed in the <string>.
unit - Specifies which unit on the stacking system. If it is not specified, it refers to the master unit.
<unit_id 1-12> - Enter the unit ID used here. This value must be between 1 and 12.
all - Specifies that all the units in the stacking system will be used.
dest_file - (Optional) Specify the path and file name of the destination file on the device.
<pathname> - Specify the path and file name of the destination file.
boot_up - Specifies it as a boot up file.
Restrictions
Only Administrator-level users can issue this command.
Example
To download firmware from an RCP server:
DGS-3420-28SC:admin#download firmware_fromRCP username rcp_user 10.90.90.90
src_file /home/DGS-3420.had
Command: download firmware_fromRCP username rcp_user 10.90.90.90 src_file
/home/DGS-3420.had
Connecting to server................... Done.
Download firmware...................... Done. Do not power off !!
Please wait, programming flash......... Done.
Saving current settings to NV-RAM...... Done.
DGS-3420-28SC:admin#
29-4 upload
Description
This command is used to upload a firmware or a configuration file from device to TFTP server.
Format
upload [cfg_toTFTP [<ipaddr> | <ipv6addr> | <domain_name 255>] dest_file <path_filename 64>
{unit <unit_id>} {src_file <pathname>} {[include | exclude | begin] <filter_string 80>
{<filter_string 80> {<filter_string 80>}} {[include | exclude | begin] <filter_string 80>
{<filter_string 80> {<filter_string 80>}} {[include | exclude | begin] <filter_string 80>
{<filter_string 80> {<filter_string 80>}}}}} | log_toTFTP [<ipaddr> | <ipv6addr> | <domain_name
255>] dest_file <path_filename 64> | attack_log_toTFTP [<ipaddr> | <ipv6addr> |
<domain_name 255>] dest_file <path_filename 64> {unit <unit_id>} | firmware_toTFTP
[<ipaddr> | <ipv6addr> | <domain_name 255>] dest_file <path_filename 64> {unit <unit_id>}
{src_file <pathname>}]