S0607080K
Page 72
Transmission and Torque Converter
(ZF 4WG-310)
4. Pull inner bearing race from plate carrier.
5. Squeeze snap ring out.
6. Disassemble end shim and plate pack K3.
7. Tilt plate carrier 90˚.
8. Loosen slotted nut.
9. Tilt plate carrier 90˚.
10. Pull off the tapered roller bearing.
CAUTION!
Slotted nut is secured with Loctite.
To prevent a damage of the thread,
heat the slotted nut before loosen it
(about 120˚C (248˚F))
Figure 133
Figure 134
Figure 135
Figure 136
To Next Page
Loading...
