Daewoo Mega 500-V - Page 398

S0607080K
Page 147
Transmission and Torque Converter
(ZF 4WG-310)
9. Adjust Axial Play of the Input Shaft
Bearing = 0.0 - 0.05 mm (0.0000 - 0.0020
in) (Figure 372 - Figure 374).
A. Mount flat gasket. Mount outer
bearing race, press it uniformly on
and determine Dimension I from the
mounting face (gasket) to the outer
bearing race.
NOTE: Dimension I e.g. 128.50 mm
(5.0591 in).
NOTE: Apply several measuring points
and determine the average
value.
B. Measure Dimension II from the
mounting face/converter bell to the
locating face/outer bearing race.
NOTE: Dimension II e.g. 127.46 mm
(5.0181 in).
C. Insert shim and position outer
bearing race until contact is obtained.
EXAMPLE K:
Dimension I 128.50 mm (5.0591 in)
Dimension II - 127.46 mm (5.0181 in)
Difference 1.04 mm (0.0409 in)
Axial Play e.g. - 0.04 mm (0.0016 in)
Gives Shim (s) = 1.00 mm (0.0394 in)
Figure 372
Figure 373
Figure 374