S0709730K
Page 18
Power Steering Unit
Return to Master Table of Contents
REASSEMBLY
NOTE:
Use bolt torque chart that follows to tighten bolts as steering unit is assembled.
1. Install springs in spool slot. See Figure 28.
Springs must be positioned as shown in
Figure 29.
2. Position springs so that amount of spring
protruding out of spool is equal on both
sides. See Figure 30.
Bolt Torque Chart
Bolt Size Torque Value
M10 4.8 kg•m (35 ft lb)
3/8 - 16 NC 4.8 kg•m (35 ft lb)
Figure 28
Figure 29
Figure 30
To Next Page
Loading...
