Delta DVP-15MC Series - Page 388

Chapter 8 Logic Instructions
8-301
8_
 Output Parameters
Parameter name Function Data type Valid range
Done TRUE when the instruction execution is completed. BOOL TRUE / FALSE
Busy TRUE when the instruction is being executed. BOOL TRUE / FALSE
Active TRUE when the instruction is being executed. BOOL TRUE / FALSE
Error TRUE while there is an error. BOOL TRUE / FALSE
ErrorID
Contains the error code when an error occurs. Please
refer to section 12.2 for the corresponding error ID.
WORD -
 Output Update Timing
Parameter Name Timing for changing to TRUE Timing for changing to FALSE
Done

When the writing of the parameter
values is finished.

When Execute changes from TRUE to
FALSE after the instruction execution is
completed
Busy
 When Execute changes to TRUE

When Done changes from FALSE to
TRUE

When Error changes to TRUE.
Active  When the instruction execution begins
 When Error changes to TRUE.
 When Done changes from FALSE
to
TRUE.
Error
 When an error occurs in the instruction
execution or the input parameters for
the instruction are illegal.
 When Execute changes from TRUE to
FALSE.
 Output Update Timing Chart
Execute
Done
Busy
Active
Error
ErrorID
Case 1 Case 2
Case 1： When Execute changes from FALSE to TRUE, Busy and Active change to TRUE. One period
later, Done changes to TRUE. Meanwhile Busy and Active changes from TRUE to FALSE. After
Execute changes from TRUE to FALSE, Done changes from TRUE to FALSE.
Case 2： When an error occurs as Execute changes from FALSE to TRUE, Error changes from FALSE
to TRUE and ErrorID shows corresponding error codes. Error changes from TRUE to FALSE
and the value in ErrorID is cleared to 0 after Execute changes from TRUE to FALSE.
 Function Explanation
The TO instruction is used to write data to the specified CR registers of the left-side module and right-side
module.
The positions of left-side and right-side modules are specified by StationID. The StationID range of right-side
module is 0~7. 0 represents the first extension analog module at the right side. 7 is the eighth extension
analog module at the right side. The StationID range of left-side module is 100~107. 100 is the first extension
module at the left side. 107 is the eighth extension analog module at the left side. If StationID value exceeds
the specified range for left-side and right-side modules, an error will occur in execution of the instruction.
If the instruction is used to write values to multiple CR registers, DesPtr need be defined as the N
th
element