Chapter 5
| SNMP Commands
SNMP Target Host Commands
– 164 –
2. private, and the access level is read/write
0 SNMP packets input
0 Bad SNMP version errors
0 Unknown community name
0 Illegal operation for community name supplied
0 Encoding errors
0 Number of requested variables
0 Number of altered variables
0 Get-request PDUs
0 Get-next PDUs
0 Set-request PDUs
0 SNMP packets output
0 Too big errors
0 No such name errors
0 Bad values errors
0 General errors
0 Response PDUs
0 Trap PDUs
SNMP Logging: Disabled
Console#
SNMP Target Host Commands
snmp-server
enable traps
This command enables this device to send Simple Network Management Protocol
traps or informs (i.e., SNMP notifications). Use the
no
form to disable SNMP
notifications.
Syntax
[
no
]
snmp-server enable traps
[
authentication
|
mac-notification
[interval
seconds]]
authentication
- Keyword to issue authentication failure notifications.
mac-notification
- Keyword to issue trap when a dynamic MAC address is
added or removed.
interval
- Specifies the interval between issuing two consecutive traps.
(Range: 1-3600 seconds; Default: 1 second)
Default Setting
Issue authentication traps
Other traps are disabled
Command Mode
Global Configuration
Command Usage
â—†
If you do not enter an
snmp-server enable traps
command, no notifications
controlled by this command are sent. In order to configure this device to send
SNMP notifications, you must enter at least one
snmp-server enable traps
command. If you enter the command with no keywords, both authentication
To Next Page
Loading...
Need help?
General