Chapter 9
| General Security Measures
Web Authentication
– 279 –
web-auth system-
auth-control
This command globally enables web authentication for the switch. Use the
no
form
to restore the default.
Syntax
[
no
]
web-auth system-auth-control
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
Both
web-auth system-auth-control
for the switch and web-auth for an interface
must be enabled for the web authentication feature to be active.
Example
Console(config)#web-auth system-auth-control
Console(config)#
web-auth
This command enables web authentication for an interface. Use the no form to
restore the default.
Syntax
[
no
]
web-auth
Default Setting
Disabled
Command Mode
Interface Configuration
Command Usage
Both web-auth system-auth-control for the switch and
web-auth
for a port must
be enabled for the web authentication feature to be active.
Example
Console(config-if)#web-auth
Console(config-if)#
To Next Page
Loading...
Need help?
General