Chapter 11
| Interface Commands
Interface Configuration
– 350 –
Interface Configuration
interface
This command configures an interface type and enters interface configuration
mode. Use the
no
form with a trunk to remove an inactive interface. Use the
no
form with a Layer 3 VLAN (normal type) to change it back to a Layer 2 interface.
Syntax
[
no
]
interface
interface
interface
ethernet
unit/port-list
unit - Unit identifier. (Range: 1)
port-list - Physical port number or list of port numbers. Separate
nonconsecutive port numbers with a comma and no spaces; or use
a hyphen to designate a range of port numbers. (Range: 1-10/28)
port-channel
channel-id (Range: 1-8)
vlan
vlan-id (Range: 1-4094)
transceiver-threshold
current
Sets thresholds for transceiver current which can be used
to trigger an alarm or warning message
IC
transceiver-threshold
rx-power
Sets thresholds for the transceiver power level of the
received signal which can be used to trigger an alarm or
warning message
IC
transceiver-threshold
temperature
Sets thresholds for the transceiver temperature which can
be used to trigger an alarm or warning message
IC
transceiver-threshold
tx-power
Sets thresholds for the transceiver power level of the
transmitted signal which can be used to trigger an alarm or
warning message
IC
transceiver-threshold
voltage
Sets thresholds for the transceiver voltage which can be
used to trigger an alarm or warning message
IC
show interfaces transceiver Displays the temperature, voltage, bias current, transmit
power, and receive power
PE
show interfaces transceiver-
threshold
Displays the alarm/warning thresholds for temperature,
voltage, bias current, transmit power, and receive power
PE
Cable Diagnostics
test cable-diagnostics Performs cable diagnostics on the specified port PE
show cable-diagnostics Shows the results of a cable diagnostics test PE
Power Savings
power-save Enables power savings mode on the specified port IC
show power-save Shows the configuration settings for power savings PE
Table 69: Interface Commands (Continued)
Command Function Mode
To Next Page
Loading...
Need help?
General