Chapter 21
| Class of Service Commands
Priority Commands (Layer 3 and 4)
– 530 –
Example
This example sets the QoS priority mapping mode to use DSCP based on the
conditions described in the Command Usage section.
Console(config)#interface 1/1
Console(config-if)#qos map trust-mode cos
Console(config-if)#
show qos map cos-
queue
This command shows the ingress CoS to eqress queue map.
Syntax
show qos map cos-queue interface
interface
interface
ethernet
unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-10/28)
Command Mode
Privileged Exec
Example
Console#show qos map cos-queue interface ethernet 1/1
CoS Information of Eth 1/1
CoS-Queue map.
CoS : CFI 0 1
---------------------------------
0 2 2
1 0 0
2 1 1
3 3 3
4 4 4
5 5 5
6 6 6
7 7 7
Console#
To Next Page
Loading...
Need help?
General