Edge-Core ECS2100-28T Reference Guide

Chapter 22 | Quality of Service Commands
– 541 –
service-policy This command applies a policy map defined by the policy-map command to the
ingress side of a particular interface. Use the
no form to remove this mapping.
Syntax
[
no ] service-policy input policy-map-name
input - Apply to the input traffic.
policy-map-name - Name of the policy map for this interface.
(Range: 1-32 characters)
Default Setting
No policy map is attached to an interface.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
◆ Only one policy map can be assigned to an interface.
◆ First define a class map, then define a policy map, and finally use the service-
policy
command to bind the policy map to the required interface.
Example
This example applies a service policy to an ingress interface.
Console(config)#interface ethernet 1/1
Console(config-if)#service-policy input rd-policy
Console(config-if)#
show class-map This command displays the QoS class maps which define matching criteria used for
classifying traffic.
Syntax
show class-map [class-map-name]
class-map-name - Name of the class map. (Range: 1-32 characters)
Default Setting
Displays all class maps.
Command Mode
Privileged Exec
Example
Console#show class-map
Class Map match-any rd-class#1

Edge-Core ECS2100-28T Specifications

General

Model	ECS2100-28T
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
MAC Address Table Size	16K
Jumbo Frame Support	9KB
VLANs	4K
Weight	3.5 kg
Storage Humidity	5% to 95% (non-condensing)
Type	Managed Switch
Ports	24 x 10/100/1000BASE-T, 4 x 1G SFP
Power Supply	AC 100-240V, 50/60Hz
Dimensions (W x D x H)	440 x 200 x 44 mm
Operating Temperature	0 to 50 °C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% (non-condensing)
Management	SNMP