Chapter 5
| SNMP Commands
General SNMP Commands
– 163 –
snmp-server location
This command sets the system location string. Use the
no
form to remove the
location string.
Syntax
snmp-server location
text
no snmp-server location
text - String that describes the system location.
(Maximum length: 255 characters)
Default Setting
None
Command Mode
Global Configuration
Example
Console(config)#snmp-server location WC-19
Console(config)#
Related Commands
snmp-server contact (162)
show snmp
This command can be used to check the status of SNMP communications.
Default Setting
None
Command Mode
Normal Exec, Privileged Exec
Command Usage
This command provides information on the community access strings, counters for
SNMP input and output protocol data units, and whether or not SNMP logging has
been enabled with the
snmp-server enable traps
command.
Example
Console#show snmp
SNMP Agent : Enabled
SNMP Traps :
Authentication : Enabled
MAC-notification : Disabled
MAC-notification interval : 1 second(s)
SNMP Communities :
1. public, and the access level is read-only
To Next Page
Loading...
Need help?
General