Chapter 19
| VLAN Commands
Editing VLAN Groups
– 460 –
vlan database
This command enters VLAN database mode. All commands in this mode will take
effect immediately.
Default Setting
None
Command Mode
Global Configuration
Command Usage
◆
Use the VLAN database command mode to add, change, and delete VLANs.
After finishing configuration changes, you can display the VLAN settings by
entering the show vlan command.
◆
Use the interface
vlan command mode to define the port membership mode
and add or remove ports from a VLAN. The results of these commands are
written to the running-configuration file, and you can display this file by
entering the show running-config command.
Example
Console(config)#vlan database
Console(config-vlan)#
Related Commands
show vlan (467)
vlan
This command configures a VLAN. Use the
no
form to restore the default settings or
delete a VLAN.
Syntax
vlan
vlan-id [
name
vlan-name]
media ethernet
[
state
{
active
|
suspend
}]
[
rspan
]
no vlan
vlan-id [
name
|
state
]
vlan-id - VLAN ID, specified as a single number, a range of consecutive
numbers separated by a hyphen, or multiple numbers separated by
commas. (Range: 1-4094)
name
- Keyword to be followed by the VLAN name.
vlan-name - ASCII string from 1 to 32 characters.
media ethernet
- Ethernet media type.
state
- Keyword to be followed by the VLAN state.
active
- VLAN is operational.
suspend
- VLAN is suspended. Suspended VLANs do not pass packets.
To Next Page
Loading...
Need help?
General
