Chapter 8
| Authentication Commands
AAA
– 216 –
aaa accounting dot1x
This command enables the accounting of requested 802.1X services for network
access. Use the
no
form to disable the accounting service.
Syntax
aaa accounting
dot1x
{
default
| method-name}
start-stop group
{
radius
|
tacacs+
|server-group}
no aaa accounting
dot1x
{
default
| method-name}
default
- Specifies the default accounting method for service requests.
method-name - Specifies an accounting method for service requests.
(Range: 1-64 characters)
start-stop
- Records accounting from starting point and stopping point.
group
- Specifies the server group to use.
radius
- Specifies all RADIUS hosts configure with the radius-server
host command.
tacacs+
- Specifies all TACACS+ hosts configure with the tacacs-server
host command.
server-group - Specifies the name of a server group configured with the
aaa group server command. (Range: 1-64 characters)
Default Setting
Accounting is not enabled
No servers are specified
Command Mode
Global Configuration
Command Usage
Note that the
default
and method-name fields are only used to describe the
accounting method(s) configured on the specified RADIUS or TACACS+ servers, and
do not actually send any information to the servers about the methods to use.
Example
Console(config)#aaa accounting dot1x default start-stop group radius
Console(config)#
To Next Page
Loading...
Need help?
General