Chapter 9
| General Security Measures
ARP Inspection
– 310 –
ip arp inspection vlan
This command enables ARP Inspection for a specified VLAN or range of VLANs. Use
the
no
form to disable this function.
Syntax
[
no
]
ip arp inspection vlan
{vlan-id | vlan-range}
vlan-id - VLAN ID. (Range: 1-4094)
vlan-range - A consecutive range of VLANs indicated by the use a hyphen,
or a random group of VLANs with each entry separated by a comma.
Default Setting
Disabled on all VLANs
Command Mode
Global Configuration
Command Usage
◆
When ARP Inspection is enabled globally with the ip arp inspection command,
it becomes active only on those VLANs where it has been enabled with this
command.
◆
When ARP Inspection is enabled globally and enabled on selected VLANs, all
ARP request and reply packets on those VLANs are redirected to the CPU and
their switching is handled by the ARP Inspection engine.
◆
When ARP Inspection is disabled globally, it becomes inactive for all VLANs,
including those where ARP Inspection is enabled.
◆
When ARP Inspection is disabled, all ARP request and reply packets bypass the
ARP Inspection engine and their manner of switching matches that of all other
packets.
◆
Disabling and then re-enabling global ARP Inspection will not affect the ARP
Inspection configuration for any VLANs.
◆
When ARP Inspection is disabled globally, it is still possible to configure ARP
Inspection for individual VLANs. These configuration changes will only become
active after ARP Inspection is globally enabled again.
Example
Console(config)#ip arp inspection vlan 1,2
Console(config)#
To Next Page
Loading...
