Edge-Core ECS2100-28T Reference Guide

Chapter 21 | Class of Service Commands
Priority Commands (Layer 2)
– 525 –
port. (Note that if the output port is an untagged member of the associated
VLAN, these frames are stripped of all VLAN tags prior to transmission.)
Example
The following example shows how to set a default priority on port 3 to 5:
Console(config)#interface ethernet 1/3
Console(config-if)#switchport priority default 5
Console(config-if)#
Related Commands
show interfaces switchport (365)
show queue mode This command shows the current queue mode.
Command Mode
Privileged Exec
Example
Console#show queue mode
Unit Port queue mode
---- ---- ---------------
1 1 Weighted Round Robin
...
show queue weight This command displays the weights used for the weighted queues.
Command Mode
Privileged Exec
Example
Console#show queue weight
Information of Eth 1/1
Queue ID Weight
-------- ------
0 1
1 2
2 4
3 6
4 8
5 10
6 12
7 14
...

Edge-Core ECS2100-28T Specifications

General

Model	ECS2100-28T
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
MAC Address Table Size	16K
Jumbo Frame Support	9KB
VLANs	4K
Weight	3.5 kg
Storage Humidity	5% to 95% (non-condensing)
Type	Managed Switch
Ports	24 x 10/100/1000BASE-T, 4 x 1G SFP
Power Supply	AC 100-240V, 50/60Hz
Dimensions (W x D x H)	440 x 200 x 44 mm
Operating Temperature	0 to 50 °C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% (non-condensing)
Management	SNMP