Chapter 19
| VLAN Commands
Configuring VLAN Interfaces
– 465 –
switchport
ingress-filtering
This command enables ingress filtering for an interface. Use the
no
form to restore
the default.
Syntax
[
no
]
switchport ingress-filtering
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
â—†
Ingress filtering only affects tagged frames.
â—†
If ingress filtering is disabled and a port receives frames tagged for VLANs for
which it is not a member, these frames will be flooded to all other ports (except
for those VLANs explicitly forbidden on this port).
â—†
If ingress filtering is enabled and a port receives frames tagged for VLANs for
which it is not a member, these frames will be discarded.
â—†
Ingress filtering does not affect VLAN independent BPDU frames, such as GVRP
or STA. However, they do affect VLAN dependent BPDU frames, such as GMRP.
Example
The following example shows how to set the interface to port 1 and then enable
ingress filtering:
Console(config)#interface ethernet 1/1
Console(config-if)#switchport ingress-filtering
Console(config-if)#
switchport mode
This command configures the VLAN membership mode for a port. Use the
no
form
to restore the default.
Syntax
switchport mode
{
access
|
hybrid
|
trunk
}
no switchport mode
access
- Specifies an access VLAN interface. The port transmits and receives
untagged frames on a single VLAN only.
hybrid
- Specifies a hybrid VLAN interface. The port may transmit tagged or
untagged frames.
To Next Page
Loading...
Need help?
General