Chapter 4
| System Management Commands
Event Logging
– 129 –
logging trap
This command enables the logging of system messages to a remote server, or
limits the syslog messages saved to a remote server based on severity. Use this
command without a specified level to enable remote logging. Use the
no
form to
disable remote logging.
Syntax
logging trap
[
level
level]
no logging trap
[
level
]
level - One of the syslog severity levels listed in the table on page 126.
Messages sent include the selected level through level 0.
Default Setting
Disabled
Level 7
Command Mode
Global Configuration
Command Usage
◆
Using this command with a specified level enables remote logging and sets the
minimum severity level to be saved.
◆
Using this command without a specified level also enables remote logging, but
restores the minimum severity level to the default.
Example
Console(config)#logging trap level 4
Console(config)#
clear log
This command clears messages from the log buffer.
Syntax
clear log
[
flash
|
ram
]
flash
- Event history stored in flash memory (i.e., permanent memory).
ram
- Event history stored in temporary RAM (i.e., memory flushed on
power reset).
Default Setting
Flash and RAM
Command Mode
Privileged Exec
To Next Page
Loading...
