Chapter 4
| System Management Commands
System Status
– 95 –
enable password 7 1b3231655cebb7a1f783eddf27d254ca
!
vlan database
VLAN 1 name DefaultVlan media ethernet
!
spanning-tree mst configuration
!
interface ethernet 1/1
no negotiation
...
interface ethernet 1/28
no negotiation
!
interface vlan 1
ip address dhcp
!
interface vlan 1
!
line console
!
line vty
!
end
!
Console#
Related Commands
show startup-config (95)
show startup-config
This command displays the configuration file stored in non-volatile memory that is
used to start up the system.
Command Mode
Privileged Exec
Command Usage
◆
Use this command in conjunction with the
show running-config
command to
compare the information in running memory to the information stored in non-
volatile memory.
◆
This command displays settings for key command modes. Each mode group is
separated by “!” symbols, and includes the configuration mode command, and
corresponding commands. This command displays the following information:
■
MAC address for
■
SNMP community strings
■
SNMP trap authentication
■
Users (names and access levels)
■
VLAN database (VLAN ID, name and state)
■
Multiple spanning tree instances (name and interfaces)
■
Interface settings and VLAN configuration settings for each interface
■
IP address for VLANs
■
Any configured settings for the console port and Telnet
To Next Page
Loading...
