Chapter 11
| Interface Commands
Interface Configuration
– 354 –
history
This command configures a periodic sampling of statistics, specifying the sampling
interval and number of samples. Use the
no
form to remove a named entry from
the sampling table.
Syntax
history
name interval buckets
no history
name
name - A symbolic name for this entry in the sampling table. (Range: 1-32
characters)
interval - The interval for sampling statistics. (Range: 1-1440 minutes.
buckets - The number of samples to take. (Range: 1-96)
Default Setting
15min - 15 minute interval, 96 buckets
1day - 1 day interval, 7 buckets
Command Mode
Interface Configuration (Ethernet, Port Channel)
Example
This example sets a interval of 15 minutes for sampling standard statistical values
on port 1.
Console(config)#interface ethernet 1/1
Console(config-if)#history 15min 15 10
Console(config-if)#
media-type
This command forces the transceiver mode to use for SFP/SFP+ ports, or
the port type to use for combination RJ-45/SFP ports. Use the no form to
restore the default mode.
Syntax
media-type
{
sfp-forced
[mode] |
sfp-preferred-auto
}
no media-type
sfp-forced
- Forces transceiver mode for the SFP/SFP+ port.
mode
1000sfp
- Always uses 1000BASE SFP mode.
100fx
- Always uses 100BASE-FX mode.
Default Setting
SFP/SFP+ ports: None
To Next Page
Loading...
