Chapter 19
| VLAN Commands
Configuring IEEE 802.1Q Tunneling
– 474 –
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
â—†
Use the
switchport dot1q-tunnel tpid
command to set a custom 802.1Q
ethertype value on the selected interface. This feature allows the switch to
interoperate with third-party switches that do not use the standard 0x8100
ethertype to identify 802.1Q-tagged frames. For example, 0x1234 is set as the
custom 802.1Q ethertype on a trunk port, incoming frames containing that
ethertype are assigned to the VLAN contained in the tag following the
ethertype field, as they would be with a standard 802.1Q trunk. Frames arriving
on the port containing any other ethertype are looked upon as untagged
frames, and assigned to the native VLAN of that port.
â—†
The specified ethertype only applies to ports configured in Uplink mode using
the switchport dot1q-tunnel mode command. If the port is in normal mode (i.e,
unspecified), the TPID is always 8100. If the port is in Access mode, received
packets are processes as untagged packets.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#switchport dot1q-tunnel tpid 9100
Console(config-if)#
Related Commands
show interfaces switchport (365)
show dot1q-tunnel
This command displays information about QinQ tunnel ports.
Syntax
show dot1q-tunnel
[
interface
interface [
service
svid] |
service
[svid]]
interface
ethernet
unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-10/28)
port-channel
channel-id (Range: 1-8)
svid - VLAN ID for the outer VLAN tag (SPVID). (Range: 1-4094)
Command Mode
Privileged Exec
To Next Page
Loading...
Need help?
General