Chapter 13
| Power over Ethernet Commands
– 398 –
Command Mode
Interface Configuration (Ethernet ports 1-8/24)
Command Usage
â—†
The number of ports which can supply maximum power simultaneously to
connected devices is listed in the following table. In this table, EPS refers to the
optional external power supply.
â—†
If a device is connected to a switch port and the switch detects that it requires
more than the maximum power allocated to the port or to the overall switch,
no power is supplied to the device (i.e., port power remains off).
Example
Console(config)#interface ethernet 1/1
Console(config-if)#power inline maximum allocation 8000
Console(config-if)#
power inline priority
This command sets the power priority for specific ports. Use the
no
form to restore
the default setting.
Syntax
power inline priority
priority
no power inline priority
priority - The power priority for the port.
Options: 1 (critical), 2 (high), or 3 (low)
Default Setting
3 (low)
Command Mode
Interface Configuration (Ethernet ports 1-8/24)
Table 79: Maximum Number of Ports Providing Simultaneous Power
Switch 30W (802.3at) 15.4W (802.3af) 7.5W (802.3af)
ECS2100-10PE 2 4 8
ECS2100-10P 4 8 8
ECS2100-28P 6 13 24
ECS2100-28PP (without EPS) 12 24 24
ECS2100-28PP (with EPS) 24 24 24
To Next Page
Loading...
Need help?
General