Chapter 17
| Address Table Commands
– 424 –
Example
Console(config)#mac-address-table aging-time 100
Console(config)#
mac-address-table
static
This command maps a static address to a destination port in a VLAN. Use the
no
form to remove an address.
Syntax
mac-address-table static
mac-address
interface
interface
vlan
vlan-id [action]
no mac-address-table static
mac-address
vlan
vlan-id
mac-address - MAC address.
interface
ethernet
unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-10/28)
port-channel
channel-id (Range: 1-8)
vlan-id - VLAN ID (Range: 1-4094)
action -
delete-on-reset
- Assignment lasts until the switch is reset.
permanent
- Assignment is permanent.
Default Setting
No static addresses are defined. The default mode is
permanent
.
Command Mode
Global Configuration
Command Usage
The static address for a host device can be assigned to a specific port within a
specific VLAN. Use this command to add static addresses to the MAC Address Table.
Static addresses have the following characteristics:
◆
Static addresses will not be removed from the address table when a given
interface link is down.
◆
Static addresses are bound to the assigned interface and will not be moved.
When a static address is seen on another interface, the address will be ignored
and will not be written to the address table.
◆
A static address cannot be learned on another port until the address is removed
with the
no
form of this command.
To Next Page
Loading...
