Chapter 20
| ERPS Commands
– 492 –
erps domain
This command creates an ERPS ring and enters ERPS configuration mode for the
specified domain. Use the
no
form to delete a ring.
Syntax
erps domain
ring-name [
id
ring-id]
no
erps domain
ring-name
ring-name - Name of a specific ERPS ring. (Range: 1-12 characters)
ring-id - ERPS ring identifier used in R-APS messages. (Range: 1-255)
Default Setting
None
Command Mode
Global Configuration
Command Usage
â—†
Service Instances within each ring are based on a unique maintenance
association for the specific users, distinguished by the ring name, maintenance
level, maintenance association’s name, and assigned VLAN. Up to 6 ERPS rings
can be configured on the switch.
â—†
R-APS information is carried in an R-APS PDUs. The last octet of the MAC
address is designated as the Ring ID (01-19-A7-00-00-[Ring ID]). If use of the
default MAC address is disabled with the no raps-def-mac command, then the
Ring ID configured by the
erps domain
command will be used in R-APS PDUs.
Example
Console(config)#erps domain r&d id 1
Console(config-erps)#
control-vlan
This command specifies a dedicated VLAN used for sending and receiving ERPS
protocol messages. Use the
no
form to remove the Control VLAN.
Syntax
[
no
]
control-vlan
vlan-id
vlan-id - VLAN ID (Range: 1-4094)
Default Setting
None
Command Mode
ERPS Configuration
To Next Page
Loading...
Need help?
General