Chapter 4
| System Management Commands
Time
– 147 –
Command Mode
Global Configuration
Command Usage
â—†
In some countries or regions, clocks are adjusted through the summer months
so that afternoons have more daylight and mornings have less. This is known as
Summer Time, or Daylight Savings Time (DST). Typically, clocks are adjusted
forward one hour at the start of spring and then adjusted backward in autumn.
â—†
This command sets the summer-time time zone relative to the currently
configured time zone. To display a time corresponding to your local time when
summer time is in effect, you must indicate the number of minutes your
summer-time time zone deviates from your regular time zone (that is, the
offset).
Example
The following example sets a recurring 60 minute offset summer-time to begin on
the Friday of the 1st week of March at 01:59 hours and summer time to end on the
Saturday of the 2nd week of November at 01:59 hours.
Console(config)#clock summer-time MESZ recurring 1 friday march 01 59 3
saturday november 1 59 60
Console(config)#
Related Commands
show sntp (139)
clock timezone
This command sets the time zone for the switch’s internal clock.
Syntax
clock timezone
name
hour
hours
minute
minutes
{
before-utc
|
after-utc
}
name - Name of timezone, usually an acronym. (Range: 1-30 characters)
hours - Number of hours before/after UTC. (Range: 0-12 hours before UTC,
0-13 hours after UTC)
minutes - Number of minutes before/after UTC. (Range: 0-59 minutes)
before-utc
- Sets the local time zone before (east) of UTC.
after-utc
- Sets the local time zone after (west) of UTC.
Default Setting
None
Command Mode
Global Configuration
To Next Page
Loading...
Need help?
General