Chapter 20
| ERPS Commands
– 497 –
Example
Console(config-erps)#meg-level 0
Console(config-erps)#
Related Commands
ethernet cfm domain (697)
ethernet cfm mep (702)
mep-monitor
This command specifies the CFM MEPs used to monitor the link on a ring node. Use
the
no
form to restore the default setting.
Syntax
mep-monitor
{
east
|
west
}
mep
mpid
east
- Connects to next ring node to the east.
west
- Connects to next ring node to the west.
mpid – Maintenance end point identifier. (Range: 1-8191)
Default Setting
None
Command Mode
ERPS Configuration
Command Usage
◆
If this command is used to monitor the link status of an ERPS node with CFM
continuity check messages, then the MEG level set by the meg-level command
must match the authorized maintenance level of the CFM domain to which the
specified MEP belongs.
◆
To ensure complete monitoring of a ring node, use the
mep-monitor
command to specify the CFM MEPs used to monitor both the east and west
ports of the ring node.
◆
If CFM determines that a MEP node which has been configured to monitor a
ring port with this command has gone down, this information is passed to
ERPS, which in turn processes it as a ring node failure. For more information on
how ERPS recovers from a node failure, refer to “Ethernet Ring Protection
Switching” in the Web Management Guide.
Example
Console(config-erps)#mep-monitor east mep 1
Console(config-erps)#
To Next Page
Loading...
Need help?
General