Chapter 4
| System Management Commands
Switch Clustering
– 152 –
Example
This example configures a time range for the periodic occurrence of an event.
Console(config)#time-range sales
Console(config-time-range)#periodic daily 1 1 to 2 1
Console(config-time-range)#
show time-range
This command shows configured time ranges.
Syntax
show time-range
[name]
name - Name of the time range. (Range: 1-32 characters)
Default Setting
None
Command Mode
Privileged Exec
Example
Console#show time-range r&d
Time-range r&d:
status: inactive
absolute start 01:01 01 April 2015
periodic Daily 01:01 to Daily 02:01
periodic Daily 02:01 to Daily 03:01
Console#
Switch Clustering
Switch Clustering is a method of grouping switches together to enable centralized
management through a single unit. Switches that support clustering can be
grouped together regardless of physical location or switch type, as long as they are
connected to the same local network.
Table 27: Switch Cluster Commands
Command Function Mode
cluster Configures clustering on the switch GC
cluster commander Configures the switch as a cluster Commander GC
cluster ip-pool Sets the cluster IP address pool for Members GC
cluster member Sets Candidate switches as cluster members GC
rcommand Provides configuration access to Member switches PE
To Next Page
Loading...
