Chapter 4
| System Management Commands
SMTP Alerts
– 133 –
logging sendmail
This command enables SMTP event handling. Use the
no
form to disable this
function.
Syntax
[
no
]
logging sendmail
Default Setting
Enabled
Command Mode
Global Configuration
Example
Console(config)#logging sendmail
Console(config)#
logging sendmail
destination-email
This command specifies the email recipients of alert messages. Use the
no
form to
remove a recipient.
Syntax
[
no
]
logging sendmail destination-email
email-address
email-address - The source email address used in alert messages.
(Range: 1-41 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
You can specify up to five recipients for alert messages. However, you must enter a
separate command to specify each recipient.
Example
Console(config)#logging sendmail destination-email ted@this-company.com
Console(config)#
To Next Page
Loading...
