Edge-Core ECS2100-28T Reference Guide

Chapter 23 | Multicast Filtering Commands
MLD Filtering and Throttling
– 599 –
Example
Console(config-mld-profile)#range ff01::0101 ff01::0202
Console(config-mld-profile)#
ipv6 mld filter
(Interface Configuration)
This command assigns an MLD filtering profile to an interface on the switch. Use
the
no form to remove a profile from an interface.
Syntax
[
no ] ipv6 mld filter profile-number
profile-number - An MLD filter profile number. (Range: 1-4294967295)
Default Setting
None
Command Mode
Interface Configuration
Command Usage
◆ The MLD filtering profile must first be created with the ipv6 mld profile
command before being able to assign it to an interface.
◆ Only one profile can be assigned to an interface.
◆ A profile can also be assigned to a trunk interface. When ports are configured as
trunk members, the trunk uses the filtering profile assigned to the first port
member in the trunk.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#ipv6 mld filter 19
Console(config-if)#
ipv6 mld max-groups This command configures the maximum number of MLD groups that an interface
can join. Use the
no form to restore the default setting.
Syntax
ipv6 mld max-groups number
no ipv6 mld max-groups
number - The maximum number of multicast groups an interface can join at
the same time. (Range: 1-255)
Default Setting
255

Edge-Core ECS2100-28T Specifications

General

Model	ECS2100-28T
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
MAC Address Table Size	16K
Jumbo Frame Support	9KB
VLANs	4K
Weight	3.5 kg
Storage Humidity	5% to 95% (non-condensing)
Type	Managed Switch
Ports	24 x 10/100/1000BASE-T, 4 x 1G SFP
Power Supply	AC 100-240V, 50/60Hz
Dimensions (W x D x H)	440 x 200 x 44 mm
Operating Temperature	0 to 50 °C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% (non-condensing)
Management	SNMP