Edge-Core ECS2100-28T - Lldp; Lldp Holdtime-Multiplier

Chapter 24 | LLDP Commands
– 607 –
lldp This command enables LLDP globally on the switch. Use the no form to disable
LLDP.
Syntax
[
no ] lldp
Default Setting
Enabled
Command Mode
Global Configuration
Example
Console(config)#lldp
Console(config)#
lldp
holdtime-multiplier
This command configures the time-to-live (TTL) value sent in LLDP advertisements.
Use the
no form to restore the default setting.
Syntax
lldp holdtime-multiplier value
no lldp holdtime-multiplier
value - Calculates the TTL in seconds based on the following rule:
minimum of ((Transmission Interval * Holdtime Multiplier), or 65536)
(Range: 2 - 10)
Default Setting
Holdtime multiplier: 4
TTL: 4*30 = 120 seconds
Command Mode
Global Configuration
Command Usage
The time-to-live tells the receiving LLDP agent how long to retain all information
pertaining to the sending LLDP agent if it does not transmit updates in a timely
manner.
Example
Console(config)#lldp holdtime-multiplier 10
Console(config)#