Chapter 11
| Interface Commands
Transceiver Threshold Configuration
– 370 –
Low Alarm: -123.00
°
C
Low Warning: 0.00
°
C
Command Mode
Interface Configuration (SFP/SFP+ Ports)
Command Usage
â—†
Refer to the Command Usage section under the transceiver-threshold current
command for more information on configuring transceiver thresholds.
â—†
Trap messages enabled by the transceiver-monitor command are sent to any
management station configured by the snmp-server host command.
Example
The following example sets alarm thresholds for the transceiver temperature at
port 1.
Console(config)interface ethernet 1/1
Console(config-if)#transceiver-threshold temperature low-alarm 97
Console(config-if)#transceiver-threshold temperature high-alarm -83
Console#
transceiver-threshold
tx-power
This command sets thresholds for the transceiver power level of the transmitted
signal which can be used to trigger an alarm or warning message.
Syntax
transceiver-threshold tx-power
{
high-alarm
|
high-warning
|
low-alarm
|
low-warning
} threshold-value
high-alarm
– Sets the high power threshold for an alarm message.
high-warning
– Sets the high power threshold for a warning message.
low-alarm
– Sets the low power threshold for an alarm message.
low-warning
– Sets the low power threshold for a warning message.
threshold-value – The power threshold of the transmitted signal.
(Range: -4000 - 820 in units of 0.01 dBm)
Default Setting
High Alarm: -9.00 dBm
HIgh Warning: -9.50 dBm
Low Warning: -11.50 dBm
Low Alarm: -12.00 dBm
Command Mode
Interface Configuration (SFP/SFP+ Ports)
To Next Page
Loading...
Need help?
General