Chapter 10
| Access Control Lists
IPv4 ACLs
– 331 –
show ip access-group
This command shows the ports assigned to IP ACLs.
Command Mode
Privileged Exec
Example
Console#show ip access-group
Interface ethernet 1/2
IP access-list david in
Console#
show ip access-list
This command displays the rules for configured IPv4 ACLs.
Syntax
show ip access-list
{
standard
|
extended
} [acl-name]
standard
– Specifies a standard IP ACL.
extended
– Specifies an extended IP ACL.
acl-name – Name of the ACL. (Maximum length: 32 characters)
Command Mode
Privileged Exec
Example
Console#show ip access-list standard
IP standard access-list david:
permit host 10.1.1.21
permit 168.92.0.0 255.255.15.0
Console#
Related Commands
permit, deny (326)
To Next Page
Loading...
Need help?
General