Chapter 8
| Authentication Commands
Telnet Server
– 230 –
◆
The client and server establish a secure encrypted connection.
A padlock icon should appear in the status bar for Internet Explorer 11, Mozilla
Firefox 40, or Google Chrome 45, or more recent versions.
The following web browsers and operating systems currently support HTTPS:
◆
To specify a secure-site certificate, see “Replacing the Default Secure-site
Certificate” in the Web Management Guide. Also refer to the copy tftp https-
certificate command.
◆
Connection to the web interface is not supported for HTTPS using an IPv6 link
local address.
Example
Console(config)#ip http secure-server
Console(config)#
Related Commands
ip http secure-port (228)
copy tftp https-certificate (102)
show system (96)
Telnet Server
This section describes commands used to configure Telnet management access to
the switch.
Table 43: HTTPS System Support
Web Browser Operating System
Internet Explorer 11 or later Windows 7, 8, 10
Mozilla Firefox 40 or later Windows 7, 8, 10, Linux
Google Chrome 45 or later Windows 7, 8, 10
Table 44: Telnet Server Commands
Command Function Mode
ip telnet max-sessions Specifies the maximum number of Telnet sessions that can
simultaneously connect to this system
GC
ip telnet port Specifies the port to be used by the Telnet interface GC
ip telnet server Allows the switch to be monitored or configured from
Telnet
GC
telnet (client) Accesses a remote device using a Telnet connection PE
show ip telnet Displays configuration settings for the Telnet server PE
To Next Page
Loading...
Need help?
General