Chapter 4
| System Management Commands
Event Logging
– 128 –
Command Usage
◆
Use this command more than once to build up a list of host IP addresses.
◆
The maximum number of host IP addresses allowed is five.
Example
Console(config)#logging host 10.1.0.3
Console(config)#
logging on
This command controls logging of error messages, sending debug or error
messages to a logging process. The
no
form disables the logging process.
Syntax
[
no
]
logging on
Default Setting
None
Command Mode
Global Configuration
Command Usage
The logging process controls error messages saved to switch memory or sent to
remote syslog servers. You can use the logging history command to control the
type of error messages that are stored in memory. You can use the logging trap
command to control the type of error messages that are sent to specified syslog
servers.
Example
Console(config)#logging on
Console(config)#
Related Commands
logging history (126)
logging trap (129)
clear log (129)
To Next Page
Loading...
