Edge-Core ECS2100-28T Reference Guide

Chapter 13 | Power over Ethernet Commands
– 395 –
power inline
maximum allocation
This command sets the maximum power allocation mode based on PD (powered
device) class or user configuration. Use the
no form to restore the default setting.
Syntax
power inline maximum allocation mode { class | user }
no power inline maximum allocation mode
class
- Power allocation is based on device classification.
user - Power allocation is based on user configuration as defined in the
power mainpower maximum allocation Global Configuration command or
the power inline maximum allocation Interface Configuration command.
Default Setting
class
Command Mode
Global Configuration
Command Usage
The IEEE standard does not define the maximum power of each PD class. The
following table is an example from Microsem's PoE IC implementation.
Example
Console(config)#power inline maximum allocation mode user
Console(config)#
Table 78: Maximum PoE Based on PD Classification
PD Class Maximum Power (Watts)
Class 0 (AF) 16.1
Class 0 (AT) 33.6
Class 1 4.2
Class 2 7.3
Class 3 16.1
Class 4 33.6

Edge-Core ECS2100-28T Specifications

General

Model	ECS2100-28T
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
MAC Address Table Size	16K
Jumbo Frame Support	9KB
VLANs	4K
Weight	3.5 kg
Storage Humidity	5% to 95% (non-condensing)
Type	Managed Switch
Ports	24 x 10/100/1000BASE-T, 4 x 1G SFP
Power Supply	AC 100-240V, 50/60Hz
Dimensions (W x D x H)	440 x 200 x 44 mm
Operating Temperature	0 to 50 °C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% (non-condensing)
Management	SNMP