Chapter 4
| System Management Commands
System Status
– 131 –
show startup-config This command displays the configuration file stored in non-volatile memory that is
used to start up the system.
Command Mode
Privileged Exec
Command Usage
◆ Use this command in conjunction with the show running-config command to
compare the information in running memory to the information stored in non-
volatile memory.
◆ This command displays settings for key command modes. Each mode group is
separated by “!” symbols, and includes the configuration mode command, and
corresponding commands. This command displays the following information:
■
MAC address for each switch in the stack
■
SNMP community strings
■
SNMP trap authentication
■
Users (names and access levels)
■
VLAN database (VLAN ID, name and state)
■
Multiple spanning tree instances (name and interfaces)
■
Interface settings and VLAN configuration settings for each interface
■
IP address for VLANs
■
Any configured settings for the console port and Telnet
Example
Refer to the example for the running configuration file.
Related Commands
show running-config (129)
show system This command displays system information.
Default Setting
None
Command Mode
Normal Exec, Privileged Exec
Command Usage
No information will be displayed under POST Result, unless there is a problem with
the unit. If any POST test indicates “FAIL,” contact your distributor for assistance.
Example
Console#show system
System Description : ECS4620-28T
System OID String : 1.3.6.1.4.1.259.10.1.41.104
To Next Page
Loading...
Need help?
General