ETAS ES800 - Heat Exchange with the Environment; Requirements for Operation; Requirements for the Transport; Setting up and Fastening the Modules

113 |
ETAS ES800 System | User Guide
13.1 Requirements for the Transport
13.2 Requirements for Operation
13.2.1 Setting Up and Fastening the Modules
The modules must be positioned securely and, for example, fastened in the vehi
-
cle:
- Position the module or the module stack on a smooth, level underground.
- The module or the module stack must always be securely fastened.
- The module or the module stack may be sloped by no more than 15°.
13.2.2 Heat Exchange with the Environment
When operating the modules, an efficient heat exchange with the environment
must be ensured:
- Keep the module away from heat sources and protect the module against
direct exposure to the sun.
- Maintain minimum distances from the module to the top and a distance of at
least 5 cm on both longitudinal sides of the system.
- The free space above and behind the module must be selected so that suf-
ficient air circulation is ensured.
- Do not cover the ventilation slots of the module!
- Do not place the module or the module stack on one of the longitudinal sides
with ventilation slots.
- Secure the module or module stack in such a way that ventilation is not com-
promised.
- Do not operate the module in completely enclosed containers.
NOTE
Possible damage or destruction of electronics!
Transport the modules of the system only with protective flap closed and pro-
tective cap attached!
WARNING
Risk of injury due to inadequate fastening
- Secure the product so that it does not move uncontrollably.
- Only use carrier systems and fastening materials that can accommodate the
static and dynamic forces of the product and are suitable for the ambient
conditions.