ETAS ES800 - ES820.1 Drive Recorder; Es8 Xx ECU and Bus Interface Module and ES830.1 Rapid Prototyping Module; Updating the Firmware

86 | Functions of the System
ETAS ES800 System | User Guide
11.7 Updating the Firmware
11.7.1 ES8xx ECU and Bus Interface Module and ES830.1 Rapid Prototyp-
ing Module
The firmware of the modules can be updated by the user so that existing modules
can be used with new properties and functions. The firmware update is done with
the help of the ETAS "Hardware Service Pack" (HSP) service software from the
connected PC. The HSP service software can be downloaded free of charge
here
on the Internet from the ETAS home page. The HSP service software is being
updated regularly.
11.7.2 ES820.1 Drive Recorder
The firmware of the ES820.1 module is updated during the installation of ES820.1
Service Packs. Further information can be found in the "Drive Recorder Configura
-
tor Tutorial" document.
NOTE
During a firmware update, neither the voltage supply to the module nor the
Ethernet connection to the PC may be interrupted.
NOTE
The "Power" button and the external "Remote Power" button must not be actu-
ated while the firmware or configuration software of the ES830.1 Rapid Prototyp-
ing Module is being updated or during installation.
NOTE
The "Power" button and the external "Remote Power" button must not be actu-
ated while the firmware or configuration software of the ES820.1 Drive Recorder
is being updated or during installation.
NOTE
ES820.1 Service Packs will be provided at a later date.