ETAS ES800 - Application Software; Extensions

32 | ES820.1 Drive Recorder
ETAS ES800 System | User Guide
5.1.3 Extensions
The Drive Recorder ES820.1 can be easily extended:
- with modules from the ES800 series in a module group (stack),
- with an Automotive Ethernet Media Converter ES162.1 at the GE Ethernet
connection,
- with USB-based interface modules (ES581.4, ES582.2, ES583.1, ES584.1),
measuring instruments and storage devices at the USB interfaces,
- with ETAS modules from other series (ES4xx, ES5xx, ES6xx, ES930) via an
ES600.2 switch at the GE Ethernet connection,
- with ETAS modules from other series (ES4xx, ES5xx, ES6xx, ES930 via an
ES88x/ ES89x ECU and Bus Interface Module in the ES800 module stack,
- with an XETK for connecting to ECUs via an ES600.2 switch at the GE Ether-
net connection.
Information on combining modules of the ES800 system with ETAS modules from
other series can be found in chapter
3.7 on page 27.
5.1.4 Application Software
The Drive Recorder ES820.1 is compatible with INCA, the standard tool for the mea-
surement, calibration and diagnostics of ECUs. The selection of measure signals,
the setting of data acquisition rates and the configuration of triggers, communica
-
tion and diagnostics protocols are performed directly by INCA.
Operating the ES820.1 Drive Recorder with Third Party Software
NOTE
Please contact the ETAS support team if you want to operate the ES820.1 Drive
Recorder with Third Party software.