ETAS ES800 - CBEB245 Cable; Fig. 17-24 CBEB245.1 Cable

200 |
ETAS ES800 System | User Guide
17.6.3 CBEB245 Cable
Fig. 17-24 CBEB245.1 cable
Usage
Cable for connecting the Automotive Ethernet interface (AE) of an ES800 module
to BR_XETKs.
Assignment of the Automotive Ethernet Channels to the Cable
Sections
The CBEB245.1 cable consists of four identical cable sections [n] with open wire
(cable tails), each mapped to an Automotive Ethernet channel [n] of the Automo
-
tive Ethernet interface (AE) and wired in accordance with the same pattern.
Labeling of the Automotive Ethernet Channels and the Cable Sec-
tions
The cable sections are labeled [n]=1 to [n]=4 and are also marked with the color of
the LEDs corresponding to the channels [n] at the AE connection of the module.
The colors of the channels [n] at the AE connection of the module and the cable
sections are identical.
When using the CBEB245.1 cable at the AE interface of the module ES882.x (three
Automotive Ethernet channels), three of the four cable harnesses are used in
accordance with the assignment in the table.
NOTE
See chapter “Requirements for failsafe Automotive Ethernet Operation” on
page 129 for details on wiring the Automotive Ethernet interface cables.
ES800 module Color Automotive Ethernet channel
"AE" LED "AE" LED/cable ES882.x ES886.x
1 Purple AE 1 AE 1
2 Orange AE 2 AE 2
3 Green AE 3 AE 3
4 Blue - AE 4
M
D
I
1
M
D
I
2
M
D
I
3
M
D
I
4
C B E B 245. 1‐0 m4
F 00K 11 1 431
CBEB245.1‐0m4
F 00 K 1 1 1 43 1
CBEB245.1‐0m4
F 00 K 1 1 1 43 1
CBEB245.1‐0m4
F 00 K 1 1 1 43 1
0
0
0
0