ETAS ES800 - Software

148 |
ETAS ES800 System | User Guide
16.8.3 Software
Web Browser
The configuration of the modules of the system is done on the PC using a graphical
user interface. A web browser application is used as the interface. No Internet
access is required for the configuration.
The ES820.1 Drive Recorder is configured by means of configuration software. The
configurations are either transferred via an Ethernet cable, the replaceable mem
-
ory module or a USB storage media to the Drive Recorder.
The status of the Drive Recorder can be determined, and a few basic settings can
be made via the web interface of the ES800 system.
ETAS Software Tools
For the configuration of ES800 system the as well as the control and data acquisi-
tion, you need ETAS software in the following versions (or higher):
Operating the ES820.1 Drive Recorder with Third Party Software
Module HSP INCA INCA-EIP INTECRIO
ES820.1 no HSP
update
V7.1.9 with
INCA-ES820
Add-On
- -
ES830.1 V11.11 V7.2.11 V7.2.11 V4.7
ES882.1 V11.7 V7.2 - -
ES882.2 V13.3.0 V7.4.3 - -
ES886.1 V11.9 V7.2.9 - -
ES886.2 V13.0 V7.4.0 - -
ES891.1 V10.9
1)
V7.1.2 - -
ES891.2 V13.3.0 V7.4.3 - -
ES891.x,
ES892.x
V10.10
2), 3)
V7.1.2 - -
V11.0
4), 5)
V7.2.0 - -
ES892.2 V13.3.0 V7.4.3 - -
1)
: ETK (Dual Mode) or FETK-S support only on FETK1/GE
2)
: ETK (Dual Mode) or FETK-S support on FETK1/GE and FETK2/GE
3)
: ETAS HW synchronization support on Fast Ethernet
4)
: FETK-T1.0 support on FETK1/GE and FETK2/GE
5)
: CAN/CAN FD, LIN and FlexRay interface support
NOTE
Please contact the ETAS support team if you want to operate the ES820.1 Drive
Recorder with Third Party software.