13 | Safety Information
ETAS ES800 System | User Guide
1.1 Intended Use
The product was developed and approved for applications in the automotive sec-
tor. Only operate the product as per its specifications. If the product is used in any
other way, product safety is no longer ensured.
The ES800 system is designed for the measurement, calibration and rapid proto-
typing of electronic systems.
ES801.1, ES801.1-S: The product is designed for supplying power to the ES800 sys
-
tem.
ES820.1: The Drive Recorder Module is designed for automatically recording and
saving data from connected ETAS modules.
ES830.1: The rapid prototyping module is designed for simultaneously performing
rapid prototyping of ECU functions and carrying out measurement and calibration
tasks on the ECU.
- Replacing real components with virtual hardware from simulation models
- Validating software function models in real time
- Testing control and diagnostics functions under real conditions
ES882.1, ES882.2, ES886.1, ES886.2, ES891.1, ES891.2, ES892.1, ES892.2:
The ECU and bus interface modules are designed for the following applications:
- Detecting signals from ETK and ECU interfaces, as well as from vehicle
buses and ETAS measuring modules
- Flash programming of ECUs
Application areas
- The product is approved for use in the following areas:
• Interior
• Passenger cell
• Trunk
- Do not operate the product in a wet or damp environment.
- Do not operate the product in potentially explosive atmospheres.
Technical Condition
The product is designed in accordance with state-of-the-art technology. Only
operate the product and its accessories if they are in perfect working order. Shut
down a damaged product immediately. Do not open or alter the product. Only ETAS
may make changes to the product.
To Next Page
Loading...
