12 | Safety Information
ETAS ES800 System | User Guide
1 Safety Information
This chapter contains information about the following topics:
• Intended Use. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
• Classification of Safety Messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
• Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
Refer to the following safety instructions and the technical documentation avail-
able to download from the ETAS website www.etas.com. Keep the information pro-
vided in a safe place.
Failure to comply with the safety instructions may lead to the risk of damage to life
and limb or property. The ETAS Group and its representatives shall not be liable for
any damage or injury caused by improper operation or use of the product.
Only use the product if you have read and understood the information concerning
safe operation and have the required qualifications and training for this product. If
you have questions about safe operation, contact ETAS:
- Technical Support: www.etas.com/hotlines
- ETAS contact partners by region: www.etas.com/contact
The product is only approved for the applications described in the technical docu-
mentation. When using and operating this product, all applicable regulations and
laws must be observed.
ETAS products made available as beta versions or prototypes of firmware, hard-
ware and/or software are to be used exclusively for testing and evaluation pur-
poses. These products may not have sufficient technical documentation and not
fulfill all requirements regarding quality and accuracy for market-released series
products. The product performance may therefore differ from the product
description. Only use the product under controlled testing and evaluation condi
-
tions. Do not use data and results from beta versions without prior and separate
verification and validation and do not share them with third parties.
Before starting up the product, check whether there is a Known Issue Report (KIR)
for that product version:
www.etas.com/kir (password: KETASIR). Note the infor-
mation given in the report.
Program codes or program control sequences that are created or changed via
ETAS products, as well as all types of data obtained through the use of ETAS prod-
ucts, must be checked for their reliability and suitability prior to use or distribution.
Only use these codes or sequences in public areas (e.g., in road traffic) if you have
ensured that the application and product settings are safe through testing in self-
contained and designated testing environments and circuits.
This ETAS product allows you to influence safety-relevant systems or data (e.g. in
motor vehicles, vehicle components and test benches). In the event of a malfunc
-
tion or a hazardous situation, it must be possible to put the system into a safe
state (e.g., emergency stop or emergency operation).
To Next Page
Loading...
