17 | Safety Information
ETAS ES800 System | User Guide
- The power supply must be suitable for use according to the ambient condi-
tions for the product.
- It is possible to discharge the vehicle battery in regular operation and long
standby operation.
- Central load-dump protection is required for operation.
Connection to the power supply (ES801.1 only)
- Only connect the product to the power supply via a suitable fuse protection.
- Ensure that the connections of the power supply are easily accessible.
Connection to the power supply (not ES801.1)
A direct connection between the product and the power supply is not permitted.
Only connect the product with an approved base module (e.g., ES801.1).
De-energizing the product
1. Disconnect the product from the power supply in one of the following ways:
- Switch off the laboratory power supply for the test setup.
- Disconnect the test setup's connection to the vehicle battery.
2. Remove all cables from the module stack.
1.3.4 Cables and Accessories
Cables
- Only use ETAS cables, cables recommended by ETAS or other cables certi-
fied for the application.
- Route the cables such that they are protected against abrasion, damage,
deformation and kinking.
- Do not place any objects on the cables.
- Do not use any damaged cables.
- The connector and connection must not be dirty.
- The connector and connection must be compatible.
- Correctly align the connector with the connection.
WARNING
Risk to life from electric shock
If an unsuitable power supply is used, this may generate a hazardous electrical
voltage.
- Use a power supply that is permitted for the product.
- Do not connect the product to power outlets.
- To prevent inadvertent connection to power outlets, use power cords with
safety banana plugs in areas with power outlets.
To Next Page
Loading...
