121 |
ETAS ES800 System | User Guide
13.4.5 Separating Modules
Required Tools
No tools or additional parts are required in order to separate the modules from one
another.
Preparations
Watch the video on separating the modules
1. Watch the video in chapter 13.4.2 on page 116 to see the steps involved in
separating the modules. Note how the top module needs to be tilted during
the separation process.
Disconnecting the Base Module from the voltage supply
2. Disconnect the Base Module of the module stack from the voltage supply.
Separating the Modules
Separating modules
1. Fold the two lateral levers up for unlocking the upper module.
2. Lift the front part of the top module.
3. Ensure that the two lateral levers for unlocking the module latch back into
place.
The top module is still latched onto the rear system connector.
4. Press down on the front edge of the top module.
The top module is separated from the bottom module.
5. Lift the top module from the module stack and place it down carefully.
NOTE
Possible damage or destruction of electronics!
Only separate the connected modules in the de-energized state.
CAUTION
Risk of crushing between the release lever and the housing
Operate the release lever in a uniform and controlled manner.
To Next Page
Loading...
