87 | Functions of the System
ETAS ES800 System | User Guide
11.8 Software Integration
In order to operate the modules with third-party application software, you will need
information about IP addresses and the software development kit.
11.8.1 Determining the IP Address of the Module
Integrating the module in third-party application software required its IP address
which you can determine with the ETAS IP Manager or with ETAS HSP service soft
-
ware.
11.8.2 Access to the FETK Interfaces
For the XCP-on-Ethernet communication, the following TCP/UDP ports are perma-
nently assigned to the FETK interfaces:
- FETK1 / GE: TCP/UDP port 1802
- FETK2 / GE: TCP/UDP port 1803
11.8.3 Access to the Vehicle Bus Interfaces
For the communication with the vehicle bus interfaces (CAN, LIN, FlexRay), ETAS
provides the software development kit "ECU and Bus Interfaces – Integration
Package" (EBI-IP). Customers can use this SDK to develop drivers for the hardware
access to integrate the module in separate application software. The ETAS EBI-IP
is available on the ETAS home page in the download center.
To Next Page
Loading...
