ETAS ES800 - Page 128

128 |
ETAS ES800 System | User Guide
3. Wait until the MEM LED goes out.
A memory module can now be inserted.
Installing another Memory Module
Installing a new memory module
1. To install the memory module, proceed as described in chapter 13.7.2
on page 123.
Fitting the Memory Slot Cover
If the removed memory module is not to be replaced by a new memory module, the
memory slot of the ES820.1 must be closed with the corresponding cover.
Fitting the memory slot cover
1. Close the memory slot of the ES820.1 module
- with a new memory module
or
2. with the memory slot cover.
Store the memory module in accordance with the ESD specifications.
MEM LED
Off
NOTE
The memory slot cover and the memory module are each secured in place in the
ES820.1 module with two push and twist closures. They can be installed and
removed without tools.
NOTE
The memory slot cover and the memory module are each secured in place in the
ES820.1 module with two push and twist closures. They can be installed and
removed without tools.