15 | Safety Information
ETAS ES800 System | User Guide
Securing the Product
The housing must not be damaged while securing the product.
Only secure the product to fastening elements intended for this.
Ventilation
- Protect the product against direct solar radiation and other sources of heat.
- Ensure that there is sufficient air circulation for efficient heat exchange.
• On both long sides, keep an area of at least 5 cm clear above and below
the product or product stack.
• Do not cover the ventilation slots.
• Do not operate the product in enclosed areas.
Interconnecting the Modules
The connector and connection must not be dirty.
Do not tilt the module during the interconnection process. Make sure that the
module fully engages.
NOTICE
Damage to the electronics due to potential equalization
The cables' shield may be connected to the housing, the ground or the ground
for the product's power supply. If there are different ground potentials in the test
setup, equalizing currents can flow between the products via the cables' shield.
Take account of different electric potentials in your test setup and take appro-
priate measures to prevent equalizing currents.
WARNING
Risk of injury due to inadequate fastening
- Secure the product so that it does not move uncontrollably.
- Only use carrier systems and fastening materials that can accommodate the
static and dynamic forces of the product and are suitable for the ambient
conditions.
CAUTION
Risk of crushing when interconnecting the modules
Make sure that your hands or fingers do not become caught between the mod-
ules.
CAUTION
Risk of crushing between the release lever and the housing
Operate the release lever in a uniform and controlled manner.
To Next Page
Loading...
