ETAS ES800 - Page 61

61 | ES886.x ECU and Bus Interface Module
ETAS ES800 System | User Guide
• Supports up to three(ES886.1)/four(ES886.2) BR_XETK / XCP-on-Ether-
net communication partners at the Automotive Ethernet connections
AE1, AE2, AE3 and/ or
• Ethernet Monitoring at the AE1, AE2, AE3 and AE4 connections and/ or
• Ethernet Monitoring with an additional internal TAP on the physical layer
via both interfaces AE1 and AE2 respectively AE3 and AE4.
Parallel communication, e.g., XCP-on-Ethernet, is not possible in this
operating mode.
• Ethernet Monitoring with an additional internal TAP on the Ethernet layer
(L2) via both interfaces AE1 and AE2 respectively AE3 and AE4.
Parallel communication, e.g., XCP-on-Ethernet, is possible in this operat-
ing mode.
• Hardware filtering for Ethernet Monitoring (at least 8 VLAN IDs are sup-
ported)
• Automatic standby function
• Precise synchronization of all connected modules and their measuring
channels
- 5 independent CAN interfaces:
• CAN FD (> 1 Mbaud) or CAN High-Speed (max. 1 Mbaud)
• CAN protocols CAN V2.0a (standard identifier with 11 bit) and CAN V2.0b
(extended identifier with 29 bit)
• Baud rate configurable via software
• ES886.2 with CAN-SIC capability
- 1 independent LIN interface: l
• LIN specification LIN V2.1
• Slave operating mode (monitoring)
- Electrical isolation of the channels from each other, from device ground and
from the supply voltage
Complete technical data for the ES886.x module can be found in the chapter
“Technical Data” on page 140.